我将Dlink-120移植到arm.9的板子上，另外一台机器通过一无线网卡与板子上的无线网卡相.连，板子作网关。 女人
现在板子上的无线网卡有时.会被u.sb hub重启，不知为啥？ 电子
dmesg的信息如下：
at76c503.c: $Id: at76c503.c,v 1..35 2003/07/30 06:.31:51 jal2. Exp $ compiled Jul 0.
at76c503.c: firmware version 1.0..0 #0 (fcs_len 4.) 美容
at76c503.c: device's MAC 00:05:5d:89:06:4b, regulatory doma.in .ETSI (Eu.rope - (S) 杀毒
a.t76c503.c: registered .wlan0.
usb.c: at76c503-rfmd driver. claimed in.terface c039de60 汽车
at76c503_.open entry 杀毒
at76c503.c: wla.n0 param: ssid okuwlan (6F6B75776C616E) mode ad.hoc ch. 10 wep dis0.
at76c503.c: wlan0 param.: preamble long .rts 1536 frag 1536 txrate auto excl 0..
at76c503.c: wlan0. p.aram: pm._mode 1 pm_period 0 auth_mode open scan_times 10 120e域名
at76c503.c: wlan.0: state 0 ->. 1 (SCANNING)外贸
at76c50.3.c: wlan0 BSS table (curr=00000000,. new=00000000):健康
at76c503.c.: wlan0: state 1 -> 6 (J.OINING) 女人
at76c503.c: wlan0 find_mat.ching_bs.s: returned 00000000( 游戏 )
at76c503.c: wlan0: state. 6 -> 8 .(STARTIBSS) 汽车
at76c503.c: using BSSID 02:00:71:04.:18.:00.
at7.6c503.c: wlan0: mgmt, but not beacon, s.ubtype = 40 建材
a.t76c.503.c: wlan0: rx newbss 电子
at76c503.c: ibss_.ch.ange = 0x 0 乙肝
a.t76c503.c: using BSSID 02:.00:71:04:18:00电影
at.76c503.c: wlan0: rx n.ewbss 鲜花
at76c503.c: ibss_ch.an.ge = 0x 0(广告)
at76c503.c: using BSSID 0.2:00:71:04:18.:00 女人
////下面就是断链的信息
hub.c: port 1, portstatus 103, c.hange 0., 12 Mb/s电脑
hub.c: p.ort 2, portstatus 101, change 2, 12 .Mb/s 女人
hub.c.: po.rt 2 enable change, status 101.
hub.c: already running por.t .2 disabled by hub (EMI?), re-enabling....
hub.c.: port 2, p.ortstatus 101, change 2, 12 Mb/s 杀毒
usb.c: USB disconn.ect on dev.ice 5.
