我有2.台服务器,都装的CentOS 4.4 汽车
服务器A,eth0.是外网IP(1.2.3.5.),eth1是内网IP(192.168.1.2),此服务器一切正常健康
服务器B,eth0是外网IP(1.2.3..4),eth1.是内网IP(192.168.1.1) 健康
两台服务器在大多数时候都工作正常.但有时候,服务器B的eth0会无故断流,.就是连ping都.ping不到.[成人用品]
我登录到A上,却.可以ping到1..2.3.4,但是,ssh 1.2.3.4就不行.
奇怪的是,当我ssh 1..92.168.1.1的以后,服务器B的eth0马上就恢复正常了投资
我查了一下服务器B的网卡配置,发现eth0和eth1居然.都是使用同一个IRQ 169,这是怎么.回事啊? .
请问,如果要.改IRQ,用什么命令?把IR.Q改成多少好??.
我很害怕远程配置网卡,因为搞不好就把网弄断了,.这样就.麻烦了!虚拟主机
[root:/etc]..#dmesg |grep eth.
divert: n.ot allocating di.vert_blk for non-ethernet device lo 乙肝
divert: allocating .dive.rt_blk for eth0[成人用品]
eth0: B.roadcom NetXtreme II BCM5708 1000Base-T (B1.) PCI-X 64-bit 133M.Hz found at mem. f8000000, IRQ 169, node addr 00188b763d5a--- 印刷
d.ivert: all.ocating divert_blk for eth1( 游戏 )
eth1: Broadcom NetXtreme II BCM5708 1000Base-T (B1) PCI-X 64..-bit 133MHz found. at mem f4000000, IRQ 169, nod.e addr 00188b763d5c( 游戏 )
b.nx2: eth1: using MSI 鲜花
bnx2: eth1 NIC Link i.s Up, 10.0 Mbps full duplex, receive & transmit flow control O.N[成人用品]
bnx2: eth0: using. MSI外贸
bnx2: eth0 NIC Link is .Up, 100. Mbps full duplex.
divert: not a.llocating divert_blk for .non-ethernet device sit0.
eth0: no .IPv6 routers p.resent 电子
eth1: no I.Pv6 route.rs present电影
bnx2:. eth1: using MSI 鲜花
ADDRCONF(NETDEV._.UP): eth1: link is not ready.
bnx2: eth1 NIC Link is. Up, 100 Mbps full dup.lex, receive & tr.ansmit flow control ON.
ADD.RCONF(NETDEV_CHANGE): e.th1: link becomes ready.
bnx2: eth0: usi.ng MSI 乙肝
ADDR.CONF(NET.DEV_UP): eth0: link is not ready电影
bnx2: eth0. NIC Link i.s Up, 100 Mbps full duplex服务器
ADDRCONF(NETDEV_.CHANGE): eth0.: link becomes ready服务器
eth1: no IPv6 ro.uters pre.sent.
eth0.: no IPv6 route.rs present电脑
